Installation Guide

17
Troubleshooting (continued)
4
There is a low flow of water or
LED indicator in the spray head
is not functioning
□ This could indicate that the washer in the "in" end of
the control box is dirty or damaged. Remove the
hose and unscrew the connector. Take out the
washer from the control box. Clear the washer
or replace the washer. Reassemble the connector
and hose.
HOMEDEPOT.COM/GLACIERBAY
Please contact 1-855-HD-GLACIER for further assistance.
3
The sensor is not activating
the water flow
□ When you turn the handle to the full on position,
the water will turn on.
□ However, when you move your hand in front
of the sensor, the water does not turn off as
it should.
□ This indicates the sensor window may need to
be cleaned. If the sensor window is clean, and
still not functioning, this means the control box
will need to be replaced. Call Glacier Bay
customer service to request a replacement
control box. Replace the old control box with the
new control box.
L
Hose
Connector
Control
box
Washer