Installation Guide

Flushing and checking for leaks

□ Pull the hose assembly out of the spout and

remove the spray head by unscrewing it from

the hose in a counterclockwise direction. Be

sure to hold the end of the hose down into the

sink and turn the faucet to the warm position

where it mixes hot and cold water.

□ Flush the water lines for one minute. This ushes

away any debris that could cause damage to

internal parts. Check for leaks.

□ Re-tighten any connections if necessary, but do

not overtighten. Reinstall the spray head by hand

tightening it back onto the spray hose in a

clockwise direction.

Operation

IMPORTANT: After installation is completed, turn on the

hot and cold water supplies. Check for leaks. Do not lose

the gasket (1) in the hose.

Making the water supply

connections

□ Thread the nut (1) on the supply line onto the

outlet of the water supply valve (2) and tighten

with a wrench. Do not overtighten.

Installation (continued)

NOTE: The hot side inlet tube is indicated by a label. Avoid

twisting wires together or placing the wires close to each

other and damaging.

HOMEDEPOT.COM/GLACIERBAY

Please contact 1-855-HD-GLACIER for further assistance.

min.