Installation Guide

14
Operation (continued)
Care and Cleaning
□ To clean, wipe down with a damp cloth and towel dry.
□ Do not use abrasive cleaners, steel wool, or harsh chemicals when cleaning this faucet, or the warranty will
be voided.
3
Removing the quick connector
□ If it is necessary to remove the quick connector
(1), squeeze the tabs (2) on the quick connector
and then pull down to disconnect.
2
Operating the sensor
□ Turn the handle (1) to the full on position, activating
the sensor (2) and turning the water on.
□ To turn the water off, move your hand within the
sensor range (8in. MAX) as shown.
NOTE: The sensor is active only when the handle is in the
ON position.
NOTE: As a water saving feature, the water will turn off
automatically after 3 minutes of continuous ow.
min.
45
30
0
15
3
□ To turn the water on, move your hand within the
sensor range again (8in. MAX range) as shown.
□ Leave the handle (1) in the ON position, and you
can start and stop the ow of water simply with
a wave of your hand.
8 in. MAX
2
1
Squeeze
2
Pull
down
1
1