Installation Guide

Installation

Installing the faucet assembly

□ Install the faucet body (A)-including supply

hoses and sensor cable (1)-through the hole

in the sink.

CAUTION: Always turn off the water supply before

removing an existing faucet or replacing any part of a

faucet. Open the faucet handle to relieve water pressure

and ensure that the water is completely shut off.

NOTE: This step is for no escutcheon installation (optional).

If the escutcheon will be used, install the faucet assembly

as described in step 2.

Installing the escutcheon

□ Screw the bolts (H) into the escutcheon (G) and

ensure that the gasket (I) is pressed onto the

escutcheon (G) before the escutcheon (G) is

installed over the three holes in the sink.

□ Secure the escutcheon (G) to the sink using the

mounting nuts (J) provided. Hand tighten only.

NOTE: If the sink is uneven, use silicone under the

gasket (I).

NOTE: This step is for escutcheon installation (optional).

If the escutcheon will not be used, install the faucet

assembly as described in step 1.

□ Shut off the water supply. Remove the old

faucet.

□ Clean the mounting surface.

□ Proceed to step 4.