Installation Guide

6
Installation (continued)
5
Installing the protective cap
□ Screw the protective cap (E) onto the threaded
mounting shank (1).
6
Installing the pulldown hose
□ Before installing the hose (K), ensure that the
protective cap (1) is on the end of the hose (K).
□ Insert the small end of the pulldown hose (K) into
the spout (2) and feed through faucet body (A)
and the threaded mounting shank (3) in the
direction shown below.
7
Attaching the quick connector
to the hose
□ Before installing the quick connector, remove
and discard the protective cap (1) from the
pulldown hose (K).
□ Attach the quick connector (N) by screwing it
onto the threaded end of the hose (K) in a
clockwise motion. Hand tighten only.
K
1
K
1
2
N
1
E
1
E
1
2
1
A
2
3
K