Installation Guide

Installation (continued)

Installing the batteries

□ To open the battery housing, squeeze the sides while pulling the cover (1). DO NOT pull on the wire.

See g 1.

□ Install the four AA batteries (Q) included by matching the positive (+) and Negative (-) ends on the battery (Q)

to the (+) and (-) markings in the battery pack (P). The negative ends of the battery (Q) should always

connect to the spring end of the battery slots in the battery pack (P). See g 2.

□ Reinstall the battery pack cover (2) by pushing up and snapping into place. See gure 3.

NOTE: When the sensor ashes 10 times continuously

and slowly, the batteries have lost their charge. Replace

the batteries (Q).

NOTE: This step is for batteries installation (optional). If the

batteries will not be used, install as described in step 12.

Figure 1 Figure 2 Figure 3

(+)

(-)

(+)

(-)