Model# 67569W-6001 67569W-6004 SKU# 703444 703440 INSTALLATION AND CARE GUIDE SINGLE-HANDLE LAVATORY FAUCET Questions, problems, missing parts? Before returning to the store, call Glacier Bay Customer Service 8 a.m. - 7 p.m., EST, Monday - Friday 9 a.m. - 6 p.m., EST, Saturday 1-855-HD-GLACIER (1-855-434-5224) HOMEDEPOT.COM THANK YOU We appreciate the trust and confidence you have placed in Glacier Bay through the purchase of this lavatory faucet.
Table of Contents Safety Information ....................................2 Warranty ...................................................2 Pre-Installation .........................................2 Planning Installation ..............................2 Tools Required .......................................2 Package Contents ..................................3 Installation ................................................4 Operation...................................................7 Care and Cleaning ........
Pre-Installation (continued) PACKAGE CONTENTS A F Q O G P H I N M L K J B C D E Part Quantity Part Description Quantity A Description Faucet assembly 1 J Pop-up body 1 B Escutcheon 1 K Clip 1 C Gasket 1 L Horizontal rod 1 D Washer 1 M Button 2 E Nut 1 N Slip joint 2 F Stopper 1 O Strap 1 G Flange 1 P Clip 1 Q Lift rod assembly 1 H Gasket 1 I Nut 1 3 HOMEDEPOT.COM Please contact 1-855-HD-GLACIER for further assistance.
Installation 1 Installing the faucet assembly 2 Installing the faucet assembly CAUTION: Always turn off the water supply before removing an existing faucet or replacing any part of a faucet. Open the faucet handle to relieve water pressure and ensure that the water is completely shut off. □ Shut off the water supply. Remove the old faucet. □ Place the spout assembly (A) through the middle mounting hole in the sink. □ Secure the spout assembly (A) with the washer (D) and the nut (E).
Installation (continued) the pop-up body and 4 Preparing the pop-up assembly 5 Installing pop-up flange Remove the stopper (F) and flange (G). Screw the nut (I) all the way down, and push the gasket (H) down. □ Apply silicone to the underside of the flange (G). □ Insert the pop-up body (J) into the sink. Screw the flange (G) onto the pop-up body (J). The pivot hole (1) must face the back of the sink. □ Use the groove joint pliers to tighten the nut (I), but do not over tighten.
Installation (continued) the horizontal rod, Adjusting the length of 6 Installing 7 stopper, and strap horizontal rod □ Install the horizontal rod (L) and stopper (F), as shown (1) and (2). Make sure the horizontal rod (L) insert into the pop-up body (J) completely, as shown (3). □ NOTE: If the horizontal rod of the pop-up assembly is too long, do not cut, it can be adjusted. Close the easy install rotating clip (K).
Installation (continued) 8 Installing the lift rod □ Slide the lift rod (Q) through the faucet assembly (A) until the knob rests on the faucet assembly. □ Push the pivot rod (L) to the down position until the stopper (F) is completely open. Press the button (M) on the slip joint assembly (N) and adjust the vertical rod (O) up or down and front or back along the pivot rod (L) until the vertical rod (O) is in the correct position to engage with the lift rod (Q).
Care and Cleaning □ □ □ Do not use abrasive cleaners when cleaning this faucet.
Questions, problems, missing parts? Before returning to the store, call Glacier Bay Customer Service 8 a.m. - 7 p.m., EST, Monday - Friday 9 a.m. - 6 p.m., EST, Saturday 1-855-HD-GLACIER (1-855-434-5224) HOMEDEPOT.COM Retain this manual for future use.
Modelo núm. 67569W-6001 67569W-6004 SKU núm. 703444 703440 GUÍA DE USO Y MANTENIMIENTO GRIFO PARA LAVAMANOS, DE UNA SOLA LLAVE ¿Problemas, preguntas o piezas faltantes? Antes de regresar a la tienda, llama al servicio al cliente de Glacier Bay de lunes a viernes entre 8 a.m. y 7 p.m. y los sábados entre 9 a.m. y 6 p.m.(hora estándar del Este) 1-855-HD-GLACIER (1-855-434-5224) HOMEDEPOT.COM GRACIAS Agradecemos la confianza que has depositado en Glacier Bay al comprar este grifo para lavamanos.
Tabla de contenido Información de seguridad ......................11 Garantía...................................................11 Pre-instalación .......................................11 Planificación de la instalación .............11 Herramientas necesarias ....................11 Contenido del paquete .........................12 Instalación ..............................................13 Funcionamiento ......................................16 Cuidado y limpieza ................................
Pre-instalación (continuación) CONTENIDO DEL PAQUETE A F Q O G P H I N M L K J B C D E Pieza Cantidad Pieza A Descripción Ensamblaje del grifo 1 J Cuerpo emergente Descripción Cantidad 1 B Placa protectora 1 K Sujetador 1 C Junta 1 L Varilla horizontal 1 Botón 2 D Arandela 1 M E Tuerca 1 N Alicate ajustable 2 F Tapón 1 O Correa 1 P Sujetador 1 Q Ensamblaje de la varilla de elevación 1 G Brida 1 H Junta 1 I Tuerca 1 12 HOMEDEPOT.
Instalación instalar el ensamblaje instalar el ensamblaje 1 Cómo 2 Cómo del grifo del grifo PRECAUCIÓN: Cierra siempre el suministro de agua antes de quitar un grifo existente o reemplazar cualquier pieza de un grifo. Abre la llave del grifo para liberar la presión de agua y asegúrate de que el suministro de agua esté completamente cerrado. NOTA: Este paso es para la instalación de la placa protectora (opcional).
Instalación (continuación) preparar el ensamblaje instalar el cuerpo 4 Cómo 5 Cómo emergente emergente y la brida emergente Retira el tapón (F) y la brida (G). Enrosca la tuerca (I) hasta el límite. Presiona la junta (H) hacia abajo. □ Aplica silicona en el lado inferior de la brida (G). □ Inserta el cuerpo emergente (J) en el lavamanos. Enrosca la brida (G) en el cuerpo emergente (J). El orificio del pivote (1) debe mirar hacia la parte trasera del lavamanos.
Instalación (continuación) instalar la varilla Cómo ajustar el largo de la 6 Cómo horizontal, el tapón y la correa 7 varilla horizontal □ Instala la varilla horizontal (L) y el tapón (F) tal como se muestra en (1) y (2). Asegúrate de que la varilla horizontal (L) se inserte completamente en el cuerpo emergente (J), como se muestra en (3) . □ Cierra el sujetador giratorio fácil de instalar (K).
Instalación (continuación) instalar la varilla de 8 Cómo elevación □ Desliza la varilla de elevación (Q) a través del ensamblaje del grifo (A) hasta que la perilla esté apoyada sobre este. □ Empuja la varilla pivotante (L) hacia abajo hasta que el tapón (F) esté completamente abierto.
Cuidado y limpieza □ Conserva el acabado del grifo aplicando cera no abrasiva. □ Cuando uses limpiadores no abrasivos, enjuaga de inmediato cuando termines de limpiar el grifo. □ No uses limpiadores abrasivos para limpiar este grifo.
¿Problemas, preguntas o piezas faltantes? Antes de regresar a la tienda, llama al servicio al cliente de Glacier Bay de lunes a viernes entre 8 a.m. y 7 p.m. y los sábados entre 9 a.m. y 6 p.m.(hora estándar del Este) 1-855-HD-GLACIER (1-855-434-5224) HOMEDEPOT.COM Conserva este manual para uso futuro.
Modèle n° 67569W-6001 67569W-6004 UGS n° 703444 703440 GUIDE D’INSTALLATION ET D’ENTRETIEN ROBINET DE LAVABO À UNE SEULE MANETTE Questions, problèmes, pièces manquantes? Avant de retourner au magasin, appelez le service à la clientèle Glacier Bay entre 8 h et 19 h, HNE, du lundi au vendredi au entre 9 h et 18 h, HNE, le samedi au 1-855-HD-GLACIER (1-855-434-5224) HOMEDEPOT.COM THANK YOU Nous vous remercions d'avoir fait confiance à Glacier Bay en achetant ce robinet de salle de bains.
Table des matières Consignes de sécurité ............................20 Garantie...................................................20 Pré-installation .......................................20 ................20 Outils requis .........................................20 Contenu de l’emballage .......................21 Installation ..............................................22 Utilisation ................................................25 Entretien et nettoyage ............................
Pré-installation (suite) CONTENU DE L'EMBALLAGE A F Q O G P H I N M L K J B C D E Pièce Description Quantité A Robinet 1 B Rosace 1 C Joint d'étanchéité D E Pièce Description Quantité J Corps d'évacuation mécanique 1 1 K Attache 1 Rondelle 1 L Tige horizontale 1 Écrou 1 M Bouton 2 Joint coulissant 2 F Bonde 1 N G Bride 1 O Courroie 1 H Joint d'étanchéité 1 P Attache 1 I Écrou 1 Q Tige de levage 1 21 HOMEDEPOT.
Installation de l'ensemble de de l'ensemble de 1 Installation 2 Installation robinetterie robinetterie ATTENTION : Coupez l’alimentation en eau CAUTION: Always turntoujours off the water supply before avant d’enlever un robinet ou de any remplacer removing an existing faucetexistant or replacing part of a n’importe quelle robinet. Ouvrezwater la poignée du faucet.
Installation (suite) 4 Préparation de l'évacuation mécanique. □ Retirez la bonde (F) et la bride (G). □ Vissez l'écrou (I) entièrement. Glissez le joint (H) vers le bas. du corps et de la 5 Installation bride d'évacuation mécanique □ Appliquez de la silicone sur le dessous de la bride (G). □ Insérez le corps d'évacuation mécanique (J) dans le lavabo. Vissez la bride (G) sur le corps d'évacuation mécanique (J). Le trou de pivot (1) doit être orienté vers l'arrière du lavabo.
Installation (suite) 6 □ Installation de la tige horizontale, de la bonde et de la courroie la longueur de la tige 7 Régler horizontale REMARQUE : Si la tige horizontale de l’évacuation mécanique est trop longue, ne la coupez pas, elle peut être ajustée. Installez la tige horizontale (L) et la bonde (F) comme illustré (1) et (2). Assurez-vous que la tige horizontale (L) est insérée complètement dans le corps d’évacuation mécanique (J) comme illustré (3).
Installation (suite) 8 Installation de la tige de levage □ Faites glisser la tige de levage (Q) dans le robinet (A) jusqu’à ce que le bouton repose sur le robinet. □ Poussez la tige du pivot (L) vers le bas jusqu’à ce que la bonde (F) soit complètement ouverte.
Entretien et nettoyage □ □ Lors de l’utilisation de nettoyants non abrasifs, rincez immédiatement lorsque vous avez terminé de nettoyer le robinet. □ N’utilisez pas de produits abrasifs pour le nettoyage de ce robinet.
Questions, problèmes, pièces manquantes? Avant de retourner au magasin, appelez le service à la clientèle Glacier Bay entre 8 h et 19 h, HNE, du lundi au vendredi au entre 9 h et 18 h, HNE, le samedi au 1-855-HD-GLACIER (1-855-434-5224) HOMEDEPOT.COM Conservez ce manuel pour référence future.