Installation Guide

5 HOMEDEPOT.COM
Please contact 1-855-HD-GLACIER for further assistance.
Installation
1
Preparing for installation
CAUTION: Always turn off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□ Shut off the water supply to the tub and
shower.
□ Verify that the hole sizes and positions of the
holes in the wall are correct：
□ The shower and tub spout outlet holes
should be 1-1/4 in. diameter.
□ The valve access hole should be 6 in.
diameter.
□ The recommended valve depth to the
nished wall is 2 in. min. to 2-1/2 in. max.
□ Ensure that the valve body (D) cover is ush
with the nished exterior surface of the wall.
Position the valve body (D) correctly in the
wall with the “UP” pointing up. The 8 in.
minimum from the valve body to the tub
spout is required for proper operation.
2
Removing the plaster guard
30 in.
Tub & Shower
8 in. Min.
48 in.
Shower Only
1 1/4 in. Diamter
1 1/4 in. Diameter
48 in.
Tub & Shower
6 in.
Diameter
30 in.
Shower Only
Unscrew the screws (K), and remove the
plaster guard (L).
□
D
L
K