Installation Guide

10
Installation (continued)
7
Installing the shower arm
□ Insert the long end of the shower arm (B) through
the shower ange (A), and wrap thread sealant
tape (not included) around the long end of the
shower arm (B) in a clockwise direction, as
shown.
Install the long end of the shower arm (B)
into the pipe elbow inside the wall. Carefully
tighten the shower arm (B) with a clean strap
wrench. Do not over tighten.
□
Wrap thread sealant tape around the pipe
threads of the tub spout outlet (1, not included)
in a clockwise direction, as shown.
□
Connect the tub spout outlet pipe (the tub
spout outlet pipe should project 1 in. to
2-15/16 in. from the nished wall) to the lower
pipe elbow (2, not included). Tighten the elbow
and tub spout outlet pipe connections with a
strap wrench.
□
8
Installing the tub spout
Place the spout (J) onto quick connection until
the spout (J) becomes ush with the nished
wall and tighten the screw (1) with with the
Hex wrench (Hex: 3.97mm, O) provided.
□
1
1 in. to 2-15/16 in.
Wall
1
2
B
A
J
O
1