Installation Guide

ManualsBrandsGlacier Bay ManualsBathBuilders 1-Handle 1-Spray Pressure Balance Shower Faucet in Brushed Nickel

Installation

Preparing for installation

CAUTION: Always turn off the water supply before

removing an existing faucet or replacing any part of a

faucet. Open the faucet handle to relieve water pressure

and ensure that the water is completely shut off.

HOMEDEPOT.COM/GLACIERBAY

Please contact 1-855-HD-GLACIER for further assistance.

30 in.

Tub & Shower

8 in. Min.

48 in.

Shower Only

1 1/4 in. Diamter

1 1/4 in. Diameter

48 in.

Tub & Shower

Refer to

the step 2

30 in.

Shower Only

Installing the valve body and

removing the plaster guard

□ Shut off the water supply to the tub and

shower.

□ Verify that the hole sizes and positions of the

holes in the wall are correct：

□ The shower and tub spout outlet holes

should be 1-1/4 in. diameter.

□ Refer to Step 2 for valve access hole

dimensions.

□ The recommended valve depth to the

nished wall is 1-1/2 in. min. to 3 in. max.

□ Ensure that the valve body (D) cover is ush

with the nished exterior surface of the wall.

Position the valve body (D) correctly in the

wall with the side marked "UP" pointing up. The

8 in. minimum from the valve body (D) to the tub

spout (J) is required for proper operation.

A. Thin Wall Installation

“Thin Walls” are usually built up with materials

such as berglass tub surrounding them and will

be the main source of support for the valve. The

plaster guard (L) remains attached to the valve.

□

B. Thick Wall Installation

“Thick Walls” are usually built up with materials such

as cement board, drywall, tile, etc. The plaster guard

(L) is positioned so that it is ush with the nished

wall. This ensures that the valve will be at the correct

position to accept the trim. The depth for the valve

body (D) in wall is measured from the center of the

shower outlet to the nished wall surface. The

accepted depth distance is 2 in. to 3 in..

□

Unscrew the screws (K), and remove the plaster

guard (L).

□

NOTE: Be sure to position the valve body (D) correctly in

the wall, with the side marked "UP" facing upward.

2 in. to 3 in.

Finished wall

6 in. dia.

3-3/8 in. to 6 in. dia.

Finished wall