Installation Guide
1
Care and Cleaning
Troubleshooting
Clean periodically with a soft cloth.
This faucet is designed for years of trouble-free performance. Keep it looking new by doing the following:
Avoid abrasive cleaners, steel wool, and harsh chemicals as these will dull the nish and void your warranty.
Problem Possible Cause Solution
There are leaks underneath the
handle.
The retainer nut has come loose
and the O-ring on the cartridge
is dirty or damaged.
Tighten the retainer nut.
Clear or replace the O-ring.
The aerator leaks or has an
inconsistent water ow pattern.
The aerator is dirty or mis-tted. Remove the aerator and check for
debris in the aerator screens.
Conrm that the rubber washer is
properly installed.
The spout leaks. The retainer nut is loose. Tighten the retainer nut.
Removing the quick connector
Push the quick connector housing on the hose (G)
upward. Hold the clip and housing together and pull
downward.
Operation(continued)
G
CAUTION: Be careful in removal of the quick connector
end of spray hose (G) to not cut hands.
NOTE: Refer to the service parts section in this manual for
a detailed drawing showing the location of the parts listed
below.
6