Installation Guide

Supply lines

Make the connections to the water lines using 1/2 in I.P.S. faucet connections (1), or

use coupling nuts (3) with 3/8 in. O.D. ball-nose risers (2) .

Use wrenches to tighten the connections. Do not over tighten.

Supply lines not included

IMPORTANT: Use two wrenches to avoid twisting the hose when tightening.

-1.2

PAGE 1
-1.2 -1.2 Supply lines IMPORTANT: Use two wrenches to avoid twisting the hose when tightening. Make the connections to the water lines using 1/2 in I.P.S. faucet connections (1), or use coupling nuts (3) with 3/8 in. O.D. ball-nose risers (2) . Use wrenches to tighten the connections. Do not over tighten.
PAGE 2
-1.2 -1.2 Líneas de suministro IMPORTANTE : Use dos llaves para evitar que gire la manguera cuando apriete. Haga las conexiones a las líneas de suministro usando conexiones de grifo I.P.S. de 1/2 pulg. (1), o use tuercas de acoplamiento (3) con tubos montantes de bola de 3/8 pulg. de diámetro externo (2) . Use llaves para apretar las conexiones. No apriete demasiado.