Installation Guide

4
Installation
A
C
I
1
D
A
E
F
P
G
2
□ Shut off the water supply. Remove the old
faucet.
□ Clean off the mounting surface.
□ Remove the lock nut (G), metal washer (F),
rubber washer (E) and rubber washer (D) from
the faucet.
□ Insert the pull-down spray hose (I), outlet hose
(C) and supply lines through the mounting hole
in the sink until faucet (A) sets on top of the
sink.
□ Slide the rubber washer (D), rubber washer (E),
metal washer (F) and lock nut (G) over outlet
hose (C). Use the lock nut (G) to secure the
rubber washer (D), rubber washer (E) and metal
washer (F).
□ Attach the extension rod (P) to lock nut (G), and
then tighten the lock nut (G).
CAUTION: Always turn off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
1
Installing the faucet assembly
2
Securing the faucet