Installation Guide

4
3
Installing the faucet assembly
Preparing the sink
D
6
Place the sink (A) into the installation hole to verify the fit. Adjust the cutout if necessary.
Install the strainer assembly as these steps describe. It is easier to install the strainer assembly to the sink before the sink is installed to
the cabinet.
Apply a small amount of plumbers putty (not included) in the notch around the drain hole of the sink (A) .
Place the strainer ring (3) on top of the drain hole in the sink (A).
Insert the screener (1) into the bowl (2) and place this assembly into the drain hole in the sink (A).
From underneath the sink (A), place the rubber washer (4), paper washer (5), locknut (6), plastic joint (7), and connecting nut (8) over
the drain hole in the sink (A).
Tighten the locknut (6) and connecting nut (8) to hold the strainer assembly securely in place.
Shut off the water supply.
Insert the faucet assembly (D) through the hole in the sink.
1
1
3
3
6
6
7
7
8
8
5
5
4
4
2
2
CAUTION: Always shut off the water supply before removing an existing faucet or
replacing any part of a faucet. Open the faucet handle to relieve water pressure and
ensure that the water is completely shut off.
Top Mount Installation (Continued)