Manualshelf

Installation Guide

ManualsBrandsGlacier Bay ManualsDrop-in Kitchen SinksTight Radius 27 in. Drop-In Single Bowl 18 Gauge Stainless Steel Workstation Kitchen Sink with Spring Neck Faucet
12345678910
5
7
6
Securing the faucet assembly
Installing the sink
rotate the clips
21
Sink
Push
up
21
1 1
Push
up
21
2
3
3
Sink
21
Sink
Continue to push up
and turn clockwise
to tighten
From underneath the sink, secure the faucet assembly to the
sink with the Fastmount
TM
system (21). Push the Fastmount
TM
system (21) up over the threads until it stops against the
bottom of the sink, then hand turn (clockwise) to tighten.
Apply silicone sealant (not included) around the underside and lip of the sink (A).
Carefully lower the sink (A) into the counter.
Rotate the clips. Tighten the screws on the top mount clips (AA) evenly until the
sink (A) is flush with the counter. Do not overtighten.
Wipe excess sealant with a rag.
Optional sink cap (J) will be available to fill the hole if the soap
dispenser or other equipment is not installed.
Top Mount Installation (Continued)
J