Manualshelf

Installation Guide

ManualsBrandsGlacier Bay ManualsDrop-in Kitchen SinksTight Radius 27 in. Drop-In Single Bowl 18 Gauge Stainless Steel Workstation Kitchen Sink with Spring Neck Faucet
12345678910
Flushing and checking for leaks
11
9
10
Removing the quick connector
If it is necessary to remove the quick connector (1), squeeze
the tabs (2) on the quick connector and then pull down to
disconnect.
Squeeze
Pull
down
1
1
2
12
Installing the accessories
Pull the hose assembly out of the spout and remove
the spray head by unscrewing it from the hose in a
counterclockwise direction. Be sure to hold the end of
the hose down into the sink and turn the faucet to the
warm position where it mixes hot and cold water.
Flush the water lines for one minute. This flushes
away any debris that could cause damage to internal
Re-tighten any connections if necessary, but do not
overtighten. Reinstall the spray head by hand tightening
it back onto the spray hose in a clockwise direction.
When finished, place the sink grid (H), cutting board (E),
basket (F), rolling grid (G) and strainer cover (I) into the sink.
D
I
E
F
H
G
IMPORTANT: After installation is completed, turn on
the hot and cold water supplies. Check for leaks.
Top Mount Installation (Continued)