Installation Guide

Installation
4
1
Installing the faucet assembly
CAUTION: Always turn off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□ Shut off the water supply. Remove the old
faucet.
□ Ensure the gasket (B) is on the bottom of the
new faucet (A).
□ Place the faucet (A) through the mounting
holes in the sink.
2
Preparing the pop-up assembly
□ Remove the pop up stopper (E) and drain
ange (F) from the drain body (I).
□ Slide the washers (C) over threaded rods. Use
the lock nuts (D) to secure the washers (C).
NOTE: If the sink is uneven, use silicone under the
gasket (B).
□ Clean the mounting surface.
E
F
G
H
I
□ Screw the lock nut (H) all the way down, and
push the rubber washer (G) down.
□ Remove the preassembled lock nuts (D) and
washers (C) from the new faucet (A).
1
A
B
2
2
C
D
D
3