Installation Guide

6
Installation (continued)
3
Installing the hot and cold
valves
□ From underneath the deck, insert the cold end
valve (K) with the rubber washer (L), metal
washer (M), and mounting nut (N) through the
hole on the right (cold) side.
□ From above, thread the ange (I) onto the
valve stem.
□ Tighten the mounting nut (N) using a basin
wrench, so that the ange (I) sits ush against
the nished deck surface.
4
Installing the handle
assemblies
□
□ Repeat this procedure for the hot end valve
(J) on the left (hot) side.
K
J
I
M
L
N
E
F
G
H
1
Place the inverters (H) and handles (G) onto the
the valve stems and secure them with the
screws (F). Use a Phillips screwdriver to tighten
the screws (F). Insert the indexes (E).