Installation Guide

Installation

Installing the faucet assembly

CAUTION: Always shut off the water supply before

removing an existing faucet or replacing any part of a

faucet. Open the faucet handle to relieve water pressure

and ensure that the water is completely shut off.

□ Shut off the water supply. Remove the old

faucet.

□ Ensure the gasket (B) is on the bottom of the

new faucet (A).

□ Place the faucet (A) through the mounting

holes in the sink.

Preparing the pop-up assembly

□ Remove the pop-up stopper (D) and drain

ange (E) from the drain body (H).

□ Secure the faucet (A) to the sink using the

mounting nuts (C) provided. Hand-tighten only.

NOTE: Silicone sealant is required under the gasket (B).

□ Clean the mounting surface.

SILICONE