Installation Guide

Installation

Preparing for installation

CAUTION: Always shut off the water supply before

removing an existing faucet or replacing any part of a

faucet. Open the faucet handle to relieve water pressure

and ensure that the water is completely shut off.

□ Shut off the water supply. Remove the old

faucet.

Installing the sprayer support

□ If your model has a side sprayer, proceed to

step 2. If your model does not have a side

sprayer, skip to step 4.

□ Insert the sprayer ange (E) through the far

right hole on the sink.

□ Screw the sprayer mounting nut (F) onto the

sprayer ange (E) shank from underneath the

sink, and hand tighten. Do not overtighten.

NOTE: The faucet with spray requires a 4 hole sink for

installation.

□ Clean the mounting surface.

□ Ensure the gasket (B) is on the bottom of the

new faucet (A).

Connecting the spray hose to

the faucet

□ Insert the side sprayer (D) hose down through

the sprayer ange (E) and sink. Align the

tabs (1 & 2) on the quick connects (3). Push the

quick connector housing rmly upward and

snap it onto the receiving tube tab. Pull down

the hose moderately to ensure the connection

has been made.