Installation Guide

7 HOMEDEPOT.COM/GLACIERBAY

Please contact 1-855-HD-GLACIER for further assistance.

Removing the quick connector

□ If it is necessary to remove the quick connector

(1), squeeze the tabs (2) on the quick connector

and then pull down to disconnect.

Pull

down

Squeeze

Operation

Flushing and checking for leaks

IMPORTANT: After installation is complete, remove the

aerator from the faucet (A) to ﬂush the water lines. Do not

lose the gasket (1) in the aerator.

□ Ensure the faucet (A) handles are in the off

position and turn on the water supply to check

for leaks. If you discover any leaks, check your

connections to ensure they are installed properly.

□ Remove the aerator and housing (if applicable).

Turn on the hot and cold handles to allow the

water to run for at least one minute. This

ﬂushes away any debris that could cause

damage to internal parts.

□ Turn off the water and reinstall the aerator and

housing (if applicable).