Installation Guide

HOMEDEPOT.COM/GLACIERBAY
Please contact 1-855-HD-GLACIER for further assistance.
15
Troubleshooting (continued)
4
There is a low flow of water
□
This could indicate that the washer in the
"in" end of the control box is dirty or damaged.
Remove the hose and unscrew the connector.
Take out the washer from the control box. Clear
the washer or replace the washer. Reassemble
the connector and hose.
□ Or the screen lter in the spray head is dirty. Turn
off the water supply at angle stop and unscrew
the spray head from spray hose. Clean the screen
lter in the spray head under running water.
3
The sensor is not activating
the water flow
□ When you turn the handle to the full on position,
the water will turn on.
□ However, when you move your hand in front
of the sensor, the water does not turn off as
it should.
□ This indicates that the control box is damaged.
Call Glacier Bay customer service to request
a replacement control box. Replace the old
control box with the new control box.
Hose
Connector
Control
box
Washer
Screen lter
H