Installation Guide

8
Installation (continued)
7
Installing the batteries
NOTE: This step is for battery installation (optional). If the
battery will not be used, install as described in step 9.
□ To open the battery housing, squeeze the tabs (1) on the cover (2), then remove the cover (2).
□ Install the four AA batteries (J) included by matching the positive (+) and Negative (-) ends on the battery (J)
to the (+) and (-) markings in the battery pack (I). The negative ends of the battery (J) should always
connect to the spring end of the battery slots in the battery pack (I).
□ Reinstall the battery pack cover (2) by pushing up and snapping into place.
NOTE: When the sensor ashes 10 times continuously
and slowly, the batteries have lost their charge. Replace
the batteries (J).
+
-
-
+
+
-
-
+
2
+
-
+
+
-
-
3
4
4
J
I
I
1
1
2
5
2