Installation Guide

Installation

2a 2b

Preparing for installation

Installing the faucet assembly

□ Install the faucet body (A)-including supply

hoses and sensor cable (1)-through the hole

in the sink.

CAUTION: Always shut off the water supply before

removing an existing faucet or replacing any part of a

faucet. Open the faucet handle to relieve water pressure

and ensure that the water is completely shut off.

NOTE: This step is for no escutcheon installation (optional).

□ Place the escutcheon (C) and gasket (D) on the

holes in the sink.

NOTE: This step is for escutcheon installation (optional).

A silicone is required under the gasket (D).

□ Install the faucet body (A)-including supply

hoses and sensor cable (1)-through the hole

in the escutcheon (C).

□ Shut off the water supply. Remove the old

faucet. Clean the mounting surface.

□ Before installation, remove the quick connector (G)

from the free end of the hose by unscrewing it in

a counterclockwise direction.

SILICONE