Installation Guide

Installation
4
1
Installing the faucet assembly
CAUTION: Always shut off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□ Shut off the water supply. Remove the old
faucet.
□ Ensure the gasket (B) is on the bottom of the
new faucet (A).
□ Place the faucet (A) through the mounting
holes in the sink.
2
Preparing the pop-up assembly
□ Remove the pop-up stopper (D) and drain
flange (E) from the drain body (H).
□ Secure the faucet (A) to the sink using the
mounting nuts (C) provided. Hand-tighten only.
NOTE: Silicone sealant is required under the gasket (B).
□ Clean the mounting surface.
D
E
H
C
B
A
SILICONE