Installation Guide

HOMEDEPOT.COM/GLACIERBAY
Please contact 1-855-HD-GLACIER for further assistance.
Installation (continued)
9
Installing the filtration system
□ Before installation, select the location for the filtration manifold (J). The screws should be placed a
minimum of 15 in. above the bottom of the floor where the filtration system is to be mounted. Any
distance lower may result in the filter set (K) interfering with the floor when removing the filters for
maintenance.
□ Use the filtration manifold (J) as a template to mark the screw hole locations where the screws are to be
installed.
Installing into drywall: Drill two 1/4 in. holes and insert the anchors (M) and screws (L).
Installing into wood: Drill two 1/8 in. holes and insert the screws (L). Do not use anchors (M).
Install screws into the wall, leaving 3/16 in. to 3/8 in. clearance between the head of the screw and wall.
11
□ Hang the filtration manifold (J) on screws (L) until the filtration manifold (J) is held firmly.
NOTE: The base of the control valve will flash red when its time to change filters and batteries. When it double flashes, 6 months have
passed and its time to replace the filters. When it flashes a single fading flash, 1 year has passed and it is time to replace the filters and
the timer batteries, then press reset button for 5 seconds to reset timer.
J
M
L
L
L
3/16 in. to 3/8 in.
Wall
15 in. Min.
1
2
2
1