Installation Guide

Installation (continued)
12
10
Installing the sensor cable
□ Install the sensor cable (1) to the connection (2) of the timer (O). Ensure the holes (3) on the sensor cable (1)
and the pillars (4) on the timer (O) are aligned to one another to ensure proper installation. Ensure they are
tightly connected by firmly pushing together.
□ If it is necessary to remove the timer (O), squeeze the tabs (5 & 6) on the sensor cable (1) and timer (O)
at the same time.
CAUTION: If the connections are made properly, the base of the control valve will flash red for 2 seconds and flash for 3 times, the
timer (O) will work. If the connections are not made properly, the timer (O) will not work.
O
1
2
3
4
6
5