Installation Guide
HOMEDEPOT.COM/GLACIERBAY
Please contact 1-855-HD-GLACIER for further assistance.
Installation (continued)
11
Installing the batteries
□ To open the timer (O), push out the cover (4).
□ Install the two AA batteries (N) included by matching the positive (+) and Negative (-) ends on the
battery (N) to the (+) and (-) markings in the timer (O). The negative ends of the battery (N) should
always connect to the spring end of the battery slots in the timer (O).
□ Reinstall the timer cover (4) by pushing into place.
NOTE: The base of the control valve will flash red when its time to change filters and batteries. When it double flashes, 6 months have
passed and its time to replace the filters. When it flashes a single fading flash, 1 year has passed and it is time to replace the filters and
the timer batteries, then press reset button for 5 seconds to reset timer.
NOTE: Use only AA Alkaline batteries. Identify the Anode (+) and the Cathode (-) to install the batteries properly.
To avoid battery damage: Do not recharge or disassemble batteries; Do not mix old batteries with new batteries; Do not use carbon
batteries; Do not expose batteries to extreme heat. Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh, etc)
batteries.
O
O
O
O
N
4
4
1
(+)
(-)
3
2
2
13