Installation Guide

Installation (continued)
5
Installing the weight
□ Insert the weight (F) onto the clip (G) by sliding
it down onto the clip (G).
□ Install the weight clip (G) at the point of the
hose marking “weight here”.
6
Making the water supply
connections
□ Attach the tee connector (H) onto the outlet of
the cold water supply valve (1) and tighten with
wrench. Do not overtighten.
□ Thread the nut (2) on the cold supply line onto
the tee connector (H) and tighten with wrench.
Do not overtighten.
□ Thread the nut (3) on the hot supply line onto
the outlet of the hot water supply valve (4) and
tighten with wrench. Do not overtighten.
NOTE: The hot side inlet tube is indicated by a label. Avoid
twisting wires together or placing the wires close to each
other and damaging.
4
3
H
C
H
2
H
H
C
1
Weight
here
Weight
here
G
G
F
F
8