Installation Guide

Installation (continued)

Installing the filtration system

□ Before installation, select the location for the ltration manifold (J). The screws should be placed a

minimum of 15 in. above the bottom of the oor where the ltration system is to be mounted. Any

distance lower may result in the lter set (K) interfering with the oor when removing the lters for

maintenance.

□ Use the ltration manifold (J) as a template to mark the screw hole locations where the screws are to be

installed.

Installing into drywall: Drill two 1/4 in. holes and insert the anchors (M) and screws (L).

Installing into wood: Drill two 1/8 in. holes and insert the screws (L). Do not use anchors (M).

Install screws into the wall, leaving 3/16 in. to 3/8 in. clearance between the head of the screw and wall.

□ Hang the ltration manifold (J) on screws (L) until the ltration manifold (J) is held rmly.

NOTE: The base of the control valve will ash red when its time to change lters and batteries. When it double ashes, 6 months have

passed and its time to replace the lters. When it ashes a single fading ash, 1 year has passed and it is time to replace the lters and

the timer batteries, then press reset button for 5 seconds to reset timer.

3/16 in. to 3/8 in.

Wall

15 in. Min.