Installation Guide

12
Installation (continued)
11
Installing the sensor cable
□ Install the sensor cable (1) to the connection (2) of the timer (O). Ensure the holes (3) on the sensor cable (1)
and the pillars (4) on the timer (O) are aligned to one another to ensure proper installation. Ensure they are
tightly connected by rmly pushing together.
□ If it is necessary to remove the timer (O), squeeze the tabs (5 & 6) on the sensor cable (1) and timer (O)
at the same time.
CAUTION: If the connections are made properly, the base of the control valve will ash red for 2 seconds and ash for 3 times, the
timer (O) will work. If the connections are not made properly, the timer (O) will not work.
O
1
2
3
4
6
5