Installation Guide

Troubleshooting

Problem Possible Cause Solution

There are leaks from the

handle.

The bonnet nut has come loose and/or the

washer is dirty or damaged.

□ Tighten the bonnet nut.

□ Clean or replace the washer.

The aerator has an

irregular or reduced

water ow.

□ Remove the aerator and

check for debris.

The water will not shut off

completely.

The cartridge is dirty or broken. □ Remove the handle to check

the cartridge.

□ Clean or replace.

The aerator is dirty or mis-tted.

NOTE: Refer to the service parts section in this manual for

a detailed drawing showing the location of the parts listed

below.

There is leaking from the

sink drain at the base of

the sink.

The sink has a rough or irregular surface. □ Apply additional silicone sealant

to the beveled side of the drain

ange.

□ Retighten and test for leaks.

There is a low ow of

water.

The screen lter in the copper tubes is dirty. □ Turn off the water supply at

angle stop and unscrew the

copper tubes from water supply

lines.

□ Remove the screen lter from

copper tubes and check for

debris.