Installation Guide

Installation (continued)

Attaching the quick connector

to the receiving block

□ Push the quick connector (H) rmly upward and

attach it to the receiving block (1). Pull down

moderately to ensure the connection has been

made.

Making the water supply

connections

NOTE: The hot side inlet tube is indicated by a label. If the

label is not present, the hot supply tube is the longer of the

two inlet tubes.

□ Use 1/2 in. I.P.S. faucet connections (2), or use

supply line coupling nuts (3) (not included) with

a 3/8 in. O.D. ball-nose riser (1).

NOTE: Before tightening the faucet connector to the water

supply, apply a second wrench to the supply tube tting.

This will prevent the supply tube from moving or twisting

when tightening the faucet connector. Do not overtighten.