Installation Guide

HOMEDEPOT.COM
Please contact 1-855-HD-GLACIER for further assistance.
15
Troubleshooting (continued)
4
There is a low flow of water
□ This could indicate that the screen filter in the
hose connectors is dirty. Turn off the water
supply at angle stop and unscrew the hose
connectors from water supply lines. Clean the
screen filter in the hose connectors under
running water.
□
Or the washer in the "in" end of the control box
is dirty or damaged. Remove the hose and
unscrew the connector. Take out the washer
from the control box. Clear the washer or replace
the washer. Reassemble the connector and hose.
□ Or the screen filter in the spray head is dirty. Turn
off the water supply at angle stop and unscrew
the spray head from spray hose. Clean the screen
filter in the spray head under running water.
3
The sensor is not activating
the water flow
□ When you turn the handle to the full on position,
the water will turn on.
□ However, when you move your hand in front
of the sensor, the water does not turn off as
it should.
□ This indicates that the control box is damaged.
Call Glacier Bay customer service to request
a replacement control box. Replace the old
control box with the new control box.
Screen filter
Screen filter
Hose
Connector
Control
box
Washer
H