Installation Guide

Installation (continued)
15 HOMEDEPOT.COM/GLACIERBAY
Please contact 1-855-HD-GLACIER for further assistance.
13
Installing the shower head
□ Attach the shower head (C) to the shower arm
(B). Hand-tighten only.
□ To clean, wipe down with a damp cloth and dry with a towel.
□ Do not use abrasive cleaners, steel wool, or harsh chemicals when cleaning this faucet, or the warranty will
be voided.
B
C
NOTE: Refer to the Service Parts section in this manual
for a detailed drawing showing the location of the parts
listed below.
Troubleshooting
Problem Possible Cause Solution
There is no hot water. □ Rotate the cartridge 180°.
□ Clean the bottom of the cartridge.
There is no ow or a low
water ow.
□ Turn both water supply valves
to the on position.
□
□ Turn off the water supply at
angle valve and unscrew the
spray head from spray hose.
Clean the screen lter in the
spray head under running water.
Refer to the step 13.
NOTE: Do not use the thread sealant tape and do not use
wrench to tighten shower head. If the screen lter (1) in
the spray head (C) is blocked, turn off the water supply at
angle valve and unscrew the spray head (C) from spray
arm (B). Clean the screen lter (1) in the spray head (C)
under running water with brush (2, not included).
□ The lines are reversed or the cartridge
is installed upside down.
□ One or both water supplies are not
turned on.
□ The stop valves are turned off or not
fully turned on.
□ The screen lter in the spray head
is blocked.
□ The balance valve in cartridge is
clogged with debris.
2
C
1
Care and Cleaning
Products are in compliance with EPA's
WaterSense Specication for Showerheads,
so the maximum ow rate value should be
below 1.8 gpm. Or consider the causes
below:
Make sure both stop valves are
fully open. Use athead
screwdriver to unscrew the valve
rod in the stop valve in a
counterclockwise direction until
the valve rod can’t be rotated.