Installation Guide

Table Of Contents

Installation (continued)

Installing the shower arm

□ Insert the long end of the shower arm (B) through

the shower ﬂange (A), and wrap thread sealant

tape (not included) around the long end of the

shower arm (B) in a clockwise direction, as

shown.

Install the long end of the shower arm (B)

into the pipe elbow inside the wall. Carefully

tighten the shower arm (B) with a clean strap

wrench. Do not over tighten.

□

Wrap thread sealant tape around the pipe

threads of the tub spout outlet (1, not included)

in a clockwise direction, as shown.

□

Connect the tub spout outlet pipe (the tub

spout outlet pipe should project

2-1/2 in. to 3 in.

from the ﬁnished wall) to the lower pipe elbow

(2, not included). Tighten the elbow and tub spout

outlet pipe connections with a strap wrench.

□

Installing the plaster guard

Place the plaster guard (I) onto the valve body (D)

and secure with the screws (H).

□

NOTE: Be sure to position the plaster guard (I) correctly

onto the valve body (D), with the side marked "SHOWER"

facing upward.

2 1/2 in. to 3 in.

Wall