Installation Guide

10
Installation (continued)
7
Installing the shower arm
□ Insert the long end of the shower arm (B) through
the shower ange (A), and wrap thread sealant
tape (not included) around the long end of the
shower arm (B) in a clockwise direction, as
shown.
Install the long end of the shower arm (B)
into the pipe elbow inside the wall. Carefully
tighten the shower arm (B) with a clean strap
wrench. Do not over tighten.
□
Wrap thread sealant tape around the pipe
threads of the tub spout outlet (1, not included)
in a clockwise direction, as shown.
□
Slide the shower ange (A) to ush with the
nished wall and tighten the set screw (O) with
the Hex wrench (Hex: 2.5 mm, H) provided.
□
Connect the tub spout outlet pipe (the tub
spout outlet pipe should project 3-19/32 in. to
3-3/4 in. from the nished wall) to the lower
pipe elbow (2, not included). Tighten the elbow
and tub spout outlet pipe connections with a
strap wrench.
□
8
Installing the tub spout
Wrap thread sealant tape around the pipe
threads of the tub spout (J) outlet in a clockwise
direction, as shown.
□
Thread the tub spout (J) onto the threaded
connection in a clockwise direction until the tub
spout (J) becomes ush with the nished wall.
□
Use the strap wrench to tighten the tub spout (J). □
Wall
3-19/32 in. to 3-3/4 in.
2
1
B
A
H
O
1
J