Installation Guide

Installation (continued)

□ Unscrew the sleeve (1) from the valve body (D).

□ Unscrew the screw (2) from the inverter (3),

and then remove the inverter (3) from the

valve body (D).

Adjusting the temperature

Removing the plastic cap

□ Before installing the escutcheon (E), remove the

plastic cap (1) from the valve body (D) by twisting

the cap in a clockwise direction when the depth

distance (which is measured from the center of

the shower outlet to the nished wall surface) is

2 in. to 2-1/2 in.. Or unscrew the screws (K) and

remove the plaster guard (L) when the depth

distance (which is measured from the center of

the shower outlet to the nished wall surface)

is 1-1/2 in. to 2 in..

NOTE: The limiter on the valve can be set to allow partial

or full access to hot water by limiting how far the handle

can be turned to the hot side of the valve. The limiter is

typically set at the factory to allow only warm water to pass

through the valve. Follow the directions in this section if you

wish to adjust the amount of hot water that is allowed

through the valve. If you do not wish to adjust the amount

of hot water that is allowed through the valve, proceed to

the step 11, and skip over the step 10 (A, B, C).

Removing the sleeve and

inverter

HOMEDEPOT.COM

Please contact 1-855-HD-GLACIER for further assistance.