Installation Guide

5 HOMEDEPOT.COM/GLACIERBAY
Please contact 1-855-HD-GLACIER for further assistance.
____A
____A
AA____
A____
Installation – Top Mount Sink
1
Preparing the countertop
2
Cutting the counter
□ Position the sink (A) upside down on the countertop.
□ Trace completely around the edge of the sink (A).
□ Draw a line 5/16” inside of the outline of the sink.
WARNING: Always wear safety goggles and gloves when
using power tools to prevent personal injury
□ Drill a pilot hole in all four corners of the inside line.
□ Use a saber saw or jig saw to cut on the inside line.
□ Place a support underneath the cutout portion of the
countertop to prevent it from falling during cutting.
3
Installing the sink
□ Apply silicone sealant (not included) around the cutout on the
countertop surface.
□ Carefully lower the sink (A) into the cutout in the countertop.
□ Preassemble the clamps and screws (AA).
□ From the underside – place the clamp (AA) in the center along
each side and hand tighten to hold sink in place. Fasten the
remaining clamps (AA) along the edges and space them
approximately 3 in. from each end, and equally along the font,
back, and sides. For countertops thicker than 3/4 in. space
them up to 1-1/2 in. apart.
□ From the top – check the seal between the sink (A) edge and
countertop. Adjust clamps (AA) if necessary.
□ Lightly tighten clamps (AA) evenly with a screw driver until the
sink is perfectly tight to the countertop. Do not over tighten.
□ Wipe away any excess sealant with a rag.