Installation Guide

ManualsBrandsGlacier Bay ManualsBathKinghurst 48 in. W x 21 in. D x 33.5 in. H Bathroom Vanity Cabinet Only in Dark Cognac

HOMEDEPOT.COM/GLACIERBAY

Please contact 1-888-774-8062 for further assistance.

Installation

PREPARING FOR INSTALLATION

NOTE: Before installation, make

sure all parts are present. Compare

parts with the Hardware Included list.

If any part is missing or damaged, do

not attempt to install the product.

□ Determine the desired mounting location,

and mark the wall where the unit will be

installed.

NOTE: For secure installation, the

unit must be mounted to at least one

wall stud.

CUTTING THE OPENING FOR

PLUMBING FIXTURES

NOTE: This step applies to vanity

cabinets with full back panels only.

□ Locate and mark plumbing on the back panel.

□ Drill a pilot hole through the back panel.

□ Use a keyhole saw to cut an opening for the

plumbing fixtures.

POSITIONING THE

CABINET

□ Move the cabinet into

place, and use wood

shims to level the

cabinet against the wall.

Use and Care Guide

Vanity Combo

HARDWARE INCLUDED

INSTALLING THE CABINET

□ For wall stud installation, insert #12 x 3 in. screws with

washers into the stud locations (not included).

□ For drywall installation, drill holes at the appropriate

locations and insert toggle bolts with washers (not included).

□ For concrete wall installation, drill 1/4 in. holes at the

appropriate locations and insert #12 wall anchors, followed

by #12 x 3 in. screws (not included).

Item # 1002 844 075

Item # 1002 835 359

Item # 1002 814 828

Model # KHWHT48D

Model # KHDOV48D

Model # KHDCOG48DY

INSTALLING THE HARDWARE

KHG48D

□ Attach the handles (AA) and the knobs (BB) to the door

the top drawer on the vanity with short screws (CC) and

to the two lower drawers on the vanity with long screws

(DD).

REMOVING THE DRAWER

Press

downw ard

Press

upward

□ Press release levers in opposite directions while pulling drawer out of the vanity.

TOOLS REQUIRED

Claw hammer Safety goggles

Phillips

Screwdriver

Caulk/sealant

Power drill

Measuring tape Wall hardware Keyhole saw Level

AA - Handle

x 7

BB - Long

Screw

x 8

CC - Medium

Screw

x 2

DD - Short

Screw

x 4

Summary of content (2 pages)

PAGE 1
Item # Item # Item # 1002 844 075 1002 835 359 1002 814 828 Model # KHWHT48D Model # KHDOV48D Model # KHDCOG48DY Use and Care Guide Vanity Combo TOOLS REQUIRED Claw hammer Safety goggles HARDWARE INCLUDED Phillips Screwdriver Caulk/sealant AA - Handle x7 Power drill Measuring tape Wall hardware Keyhole saw BB - Long Screw x8 CC - Medium Screw x2 DD - Short Screw x4 Level Installation 1 PREPARING FOR INSTALLATION NOTE: Before installation, make sure all parts are present.
PAGE 2
Installation (continued) 7 RE-INSTALLING THE DRAWER NOTE: Drawer should install smoothly; however, there may be minor resistance when the drawer is approximately half to two-thirds installed. This is normal. A □□ Move the ball bearing cages to the front and push the rear of the glides toward the center of the vanity. □□ Insert the drawer box. □□ Ensure the drawer box glide members slide through the plastic guide at the front of the vanity member on each side. A LIATED 3. ELACS A A LIATED 3.