Installation Guide
HOMEDEPOT.COM/GLACIERBAY
Please contact 1-888-774-8062 for further assistance.
Use and Care Guide
Bath Storage Cabinet
TOOLS REQUIRED
Claw hammer Safety goggles Phillips screwdriver Power drill
Measuring tape Wall hardware Level
HARDWARE INCLUDED
AA - Knob
x 2
BB - Knob Screw
x 2
CC - Shelf Clip
x 8
DD - Shelf
x 2
2
PREPARING THE CABINET
□ Drill 1/8 in. diameter holes through the back
panel of the cabinet on all four corners.
Installation
1
DETERMINING THE MOUNTING LOCATION
NOTE: Before installing, make sure all parts are present. Compare parts
with the Hardware Included list. If any part is missing or damaged, do not
attempt to install the product.
□ Determine the desired mounting location, and mark the wall
where the unit will be installed.
3
INSTALLING THE CABINET
□ For wall stud installation, insert #12 x 3 in. screws with washers into the stud locations (not included).
□ For drywall installation, drill holes at the appropriate locations and insert toggle bolts with washers
(not included).
□ For concrete wall installation, drill 1/4 in. holes at the appropriate locations and insert #12 wall
anchors, followed by #12 x 3 in. screws (not included).
4
INSTALLING THE SHELF
□ Insert the provided shelf clips (CC) into the holes on
the inside of the cabinet.
□ Rest the shelf (DD) on the shelf clips (CC).
5
INSTALLING THE KNOBS
□ Attach the knobs (AA) to the cabinet with the knob
screws provided (BB).
CC
BB
DD
AA
Item #1001 768 032
Item #1001 768 031
Model #TTDEC-WHT
Model #TTDECFG-WHT