Installation Guide

5 HOMEDEPOT.COM/GLACIERBAY

Please contact 1-855-HDGLACIER for further assistance.

Installation (continued)

Cutting the installation hole

□ Drill a pilot hole and cut the countertop opening. Use the

appropriate cutting tool for the surface you are cutting and

cut along the inside of the template line.

Marking the clip locations

□

Place the sink underneath the countertop cutout; and check if the cutout is t for the sink; adjust the cutout if necessary.

Place a stand under the sink to facilitate installation and avoid dropping.

Place the mounting clips (AA) as shown in the attached template and mark the centers of the clip on the countertop.

□

Preparing the countertop

□

e th

line

for FLUSH MOUNT CUT

Cutout for U

nder M

oun

t I

nsta

llat

ion

Check the template (B) and select the cutline you want: line B1

is bowl size; line B2 is 1/2 in. wider than bowl size. If you choose

line B1, please tear off the template through the broken line.

Place the template (B) on the countertop. Ensure the

template is centered on the counter so that it is parallel

to the counter edge and that the installation hole will not

interfere with the structure of the cabinet.

Tape the template (B) to the countertop to keep it in place

and trace the cutout line on the template (B) with a pencil.

r FL USH MOUNT CUT.

nder Moun

t Installation

Drilling the mounting holes

□

Drill mounting holes in the clip center mark from the previous step.

Insert the inserts (BB) in the holes so they are completely inside the hole. If necessary, gently tap the insert.