Installation Guide

7 HOMEDEPOT.COM
Please contact 1-855-HDGLACIER for further assistance.
Undermount Installation (continued)
1
Preparing the countertop
□ Place the undermount side of the template (B) on the
countertop. Ensure the template (B) is centered on the
counter so that it is parallel to the counter edge and that
the installation hole will not interfere with the structure of
the cabinet.
□ Tape the template (B) to the countertop to keep it in place
and trace the cutout line on the template (B) with a pencil.
B
2
Cutting the installation hole
□ Drill a pilot hole and cut the countertop opening. Use the
appropriate cutting tool for the surface you are cutting and
cut along the inside of the template line.
3
Drilling holes for the clamps
□ On the underside of the counter, mark the location of
the twelve holes for the clips (not included). These holes
should be equally spaced around the perimeter of the
cutout.
□ Using an electric drill with a 11 mm drill bit, drill each hole
so that it is 11 mm in diameter and
13 mm deep.
□ Insert the plastic caps from each of the clips (not included)
into each of the installation holes.
4
Installing the sink
□ Insert the screws (1) attached to the 65 mm and 50 mm
clips (AA and BB) loosely in the holes that you drilled in
the underside of the counter. Ensure that you use the 50
mm clips (BB) in the locations that have the narrowest
clearance between the sink and counter.
□ Place a small bead of silicone sealant (not included) around
the upper lip of the sink (A).
□ Carefully place the sink (A) into its location under the
counter, with the lip of the sink being supported by the
clips (not included).
□ Tighten the screws (1) evenly, ensuring the sink (A) remains
in place.
□ Wipe away any excess silicone and, for best results, allow
the bond to rest undisturbed for 8 hours or overnight.
1
A