Use and Care Manual

7 HOMEDEPOT.COM
Please contact 1-877-527-0313 for further assistance.
ANTI-LEAK BOTTLE SUPPORT COLLAR
The bottle support collar (A) on your water dispenser is engineered with a
special anti-leak-proof system to prevent accidental loss of water, (ooding)
as a result of inadvertently installing a defective water bottle. Unfortunately,
not all water bottles are created equal. Almost all 3 and 5 gallon (12 and
19 L) water bottles are recycled and handled extensively during cleaning,
lling, and shipping. As a result, they are very prone to developing hairline
fractures and pinhole leaks that are not always obvious to the end user until
the time of installation.
If you are experiencing a leak, this simple test will allow you to determine
whether your water bottle or dispenser is the source of the problem.
□ Unplug the unit and remove the water bottle.
□ Remove the bottle support collar (A) and check the water level inside
the reservoir. It should be roughly three quarters full.
□ Add or drain a few glasses of water to achieve the required ll level.
□ Closely monitor the water level inside the reservoir (1-2 hours). If the
water level drops, immediately drain the remaining water from the unit
and call customer service at 1-877-527-0313. If the water level remains
constant, it is the water bottle and not the dispenser that is leaking.
Please contact your water supplier for a replacement bottle.
IMPORTANT: Never knowingly install a defective water bottle on a
water dispenser. Return immediately for replacement.
Vent Tube
Water Level
READY-TO-DISPENSE INDICATOR LIGHTS
FLASHING The heater (hot water tank) is operational.
STEADY ON The hot water has reached optimum temperature and is ready for dispensing.
OFF
The hot water tank is off, however remaining water within the tank may still be
very hot. Always exercise caution when dispensing and/or draining water from
the hot water tank.
STEADY ON The cold water has reached optimum temperature and is ready for dispensing.
OFF
The cooling cycle is in progress. It is possible to dispense water during the
cooling cycle; however, optimum cooling temperature may not yet be achieved.
FLASHING The water level inside the internal reservoir is low. The water bottle is empty.
OFF
The status of all water levels are normal.
RED
BLUE
YELLOW
A
Pre-Operation (continued)