Instructions / Assembly

3
Install the Casters
1. Insert the carriage-head bolts into the keyhole slots and slide the
bolts into place as shown.
2. Position the two rigid casters over the bolts in the front cabinet
location, with the brakes toward the inside, and start four self-
locking nuts for each caster.
3. Hold the casters in place making sure the bolts are seated in the
narrow ends of the keyhole slots. Tighten the self-locking nuts
with a ⁷⁄₁₆" wrench.
4. To attach the two swivel casters to the rear caster location,
repeat Steps 2 and 3.
5. Return the cabinet to its upright position.
6. Replace the top mat with the textured side facing up.
7. Unlock the doors or drawers.
8. Place the liner(s) in the tray or the drawers.
Install the Convertible Tray or Drawers
Removing the Convertible Tray or Drawer
1. Unload the contents from the convertible tray or drawer.
2. Slide out the convertible tray or drawer as far as it will go.
3. Press the lever down on the right-hand track and lift the lever up
on the left track to release the convertible tray or drawer.
Replacing the Convertible Tray or Drawer
1. Align the convertible tray or drawer guides with the receiving
glides.
2. Hold the receiving glides firmly and insert the convertible tray or
drawer guide.
NOTE: It is normal for the convertible tray or drawer to close
tightly the first time after it has been removed.
3. Push the convertible tray or drawer in completely.
Adjust Drawer Location
(optional on GearDrawer only)
You can remove the drawer glides and reinstall them in different
locations to customize your storage space.
Removing the Glide
1. Unload the drawer and remove it. See “Install the Convertible
Tray or Drawers.”
2. Insert a flat-blade screwdriver between the glide and the cabinet
just past the first opening.
3. Using the screwdriver, pry the glide up and push it back toward
the rear of the cabinet.
Replacing the Glide
1. Determine the desired height for the drawer.
2. Insert the glide tabs into the openings in the cabinet.
3. Hold the back of the glide and pull it toward you until it locks into
place.
4. Replace the drawer. See “Install the Convertible Tray or
Drawers.”
A. Swivel casters
B. Caster plate
C. Rigid casters
D. Front of cabinet
A. Lever
A
B
D
C
A
A. First opening
B. Back of glide
B
A