Instructions / Assembly

ManualsBrandsGladiator ManualsStorage & Organization28 in. W x 31 in. H x 18 in. D Freestanding 2-Door Steel Cabinet in Hammered Granite

3. Stand the cabinet upright.

4. If you have not already, fasten the two bolts at each front corner,

of the cabinet frame. Completely tighten all the cabinet bolts and

nuts.

Assemble Drawer

IMPORTANT:

■ Position the drawer sides so that the glides are at the top and

facing the outside.

■ Do not fully tighten the six screws attaching the drawer back to

the sides.

1. Using three Phillips-head screws (F3c), attach the side (D1) to the

back (D2) as shown.

NOTE: Working from the back, insert the screws through the

drawer back and then into the drawer side.

2. Using three Phillips-head screws (F3c), attach side (D3) to the

back (D2) as shown.

NOTE: Working from the back, insert the screws through the

drawer back and then into the drawer side.

3. Working from the top, set the drawer bottom (D4) down onto the

back and side flanges as shown.

4. Working from the bottom, insert screws through the drawer back

and sides and then into the drawer bottom.

NOTE: Wait until the drawer front is in place before inserting the

screws that attach the drawer bottom to the front.

5. Using nine Phillips-head screws (F3c), attach the drawer front

(D5) to the bottom and sides.

6. Before you insert the drawer into the cabinet, make sure the

bearing carriages on the cabinet slides are at the front of the

cabinet.

7. Align the drawer glides with the slides on the inside of the

cabinet. Insert the drawer glides into the slides and push the

drawer into the cabinet.

NOTE: If the drawer glide is not correctly aligned with the cabinet

slide, the drawer may become lodged in the cabinet. Facing the

cabinet, press down on the lever located on the right-hand

drawer glide while pressing up on the lever located on the left-

hand drawer glide to release the drawer.

8. Once the drawer is in place, work from the rear of the cabinet to

completely tighten the six screws attaching the drawer back.

Attach Upper Back Panel

1. Align back panel (P5) with the holes in the top (P2). Using seven

Phillips-head screws (F3c), attach back panel (P5) to the top (P2)

and sides (P1 and P3) as shown. Do not tighten screws

completely.

NOTE: Back panel (P5) will slightly overlap back panel (P6)

2. Using two Phillips-head screws (F3c), attach the upper back

panel (P5) to the lower back panel (P6) as shown.

A. Leveling legs

F3c

F3c Phillips-head screw (22 - black)

A. Drawer glide lever

A. Tighten drawer screws.

F3c

F3c Phillips-head screw (9 - black)