Installation Guide

2. Attach Lower Back Panel 3. Install Leveling Legs

Using seven Phillips-head screws (F3c), attach the lower back

panel (P6) to the bottom (P4) and sides (P1 and P3) as shown.

Tighten screws completely. Using the hex key (provided),

completely tighten all the cabinet bolts and nuts.

NOTE: The Gladiator

Modular GearBox is designed to be

either stationary or to roll on casters. To order the Gladiator

Steel Modular GearBox Caster Kit, see “Accessories.” Place the

cabinet on its side. Screw a leveling leg (P7) into each of the four

rivet nuts located at the corners of the cabinet as shown. Stand

the cabinet upright. If you have not already, fasten the two bolts

at each front corner, of the cabinet frame. Completely tighten all

the cabinet bolts and nuts.

F3c

F3c Phillips-head screw (7)

A. Leveling legs