Use and Care Guide

Installing the Overhead GearLoft™ Storage Rack

WARNING

Excessive Weight Hazard

Use two or more people to move storage rack.

Failure to do so can result in back or other injury.

1. Attach the EZ Connect supports

Using two or more people, the rack system can be easily lifted

and positioned overhead. The EZ Connect feature allows for

positioning 23" to 37.8" from the ceiling. Lift the rack into place

and connect the lower supports to the upper supports. Make sure

the rack supports are facing the same way and the rack is level.

Make sure all bolts and screws are tight. Once the rack is in the

desired location below the ceiling, place an EZ Connect locking

pin (F5) in a hole on each of the corner and center supports to

lock/retain them together. The pins go through both upper and

lower supports.

NOTE: The rack system can be repositioned up or down by

removing all locking pins and relocating the EZ Connect position

on the supports. Use two or more people to relocate the rack and

replace the EZ Connect locking pins (F5).

2. Complete the assembly

EZ Connect locking pin

Storage Rack Care

■ Wash storage rack with a mild liquid detergent and warm water using a soft, clean cloth.

■ Check fastener tightness annually.

Registering Your Product

There are many benets of registering your product. Find out more and register your product online at

www.gladiatorgarageworks.com. In the USA, call 1-866-342-4089. Consumers in Canada can call 1-800-807-6777.

11-Nov-2019 09:35:29 EST | RELEASED

In some European factories the letter "W" of the part code mentioned herein will be automatically

replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")