Installation Guide
9
Lock the front casters and insert a small piece of cardboard
between the caster brake and the floor. This will help prevent
the brake from rubbing on the floor.
NOTE: Locking the casters will help prevent the refrigerator or
freezer from moving while it is being lifted.
Align a front caster (with a brake) with the holes in the caster
bracket. Make sure that the brake faces the outside of the
product. Insert and hand-tighten 1/2" caster bolts into each
of the four caster bracket holes. Once all four caster bolts are
installed, tighten the bolts with a 1/2" wrench or ratchet with
an extender. Repeat installation with the other front caster
(brake) and the two rear casters (no brake).
Helpful Tip: Rotate the caster to gain access to bolt locations.
Stand the refrigerator or freezer upright.
Align the right-hand caster brackets and drive in the rear bracket
screws with the TORX
®
T40
®
screwdriver from step 3.
Pushing
the brackets against the bottom of the refrigerator or freezer,
reinstall the upper and lower hex-head bolts with a TORX
®
T25
®
screwdriver or a 3/8" nut driver. Repeat on the
left-hand side.
5. Install Caster Brackets 6. Attach Casters
8. Stand Unit Upright7. Lock Front Casters