Installation Sheet

9
Lock the front casters and insert a small piece of cardboard
between the caster brake and the floor. This will help prevent
the brake from rubbing on the floor.
NOTE: Locking the casters will help prevent the refrigerator or
freezer from moving while it is being lifted.
Align a front caster (with a brake) with the holes in the caster
bracket. Make sure that the brake faces the outside of the
product. Insert and hand-tighten 1/2" caster bolts into each
of the four caster bracket holes. Once all four caster bolts are
installed, tighten the bolts with a 1/2" wrench or ratchet with
an extender. Repeat installation with the other front caster
(brake) and the two rear casters (no brake).
Helpful Tip: Rotate the caster to gain access to bolt locations.
Stand the refrigerator or freezer upright.
Align the right-hand caster brackets and drive in the rear bracket
screws with the TORX T40 screwdriver from step 3. Pushing
the brackets against the bottom of the refrigerator or freezer,
reinstall the upper and lower hex-head bolts with a TORX T25
screwdriver or a 3/8" nut driver. Repeat on the
left-hand side.
5. Install Caster Brackets 6. Attach Casters
8. Stand Unit Upright7. Lock Front Casters